AX700 [ 6 DUTY / 1 STANDBY AMPLIFIER CHANGEOVER PANEL ]
________________________________________________________________________________________
INTRODUCTION
AX700 is a platform for standby amplifier to take over failed duty unit in an automated changeover setup. Each unit caters for 6 duty and 1 standby amplifier but expandable to larger setup with a single standby power pack.
It shall be used with amplifiers with auto fault sensing (AFS) such as PX series and whereas normal amplifiers are used, Amperes AS4000 shall be installed at every duty unit. In such case, we recommend that Amperes AX3700 to be used instead.
AX700 has protection features that only allow a single take over to prevent overloading.
FEATURES
 |
Cater for 6 duty and 1 standby amplifier |
|
Expandable for 1 standby to serve more than 6 duty units |
|
Overload protection by allowing only a single take over |
|
Prioritized changeover - unit with higher number is preferred for changeover |
|
Fault alert with LED indicator and switchable buzzer |
|
Compatible with most auto detection cards |
TECHNICAL SPECIFICATIONS
| Operating voltage |
24V DC via PS9400 PSU |
| Power consumption |
Standby : 82 mW, 3.4A |
| Operating : 1.3W, 50 mA |
| Zone load rating |
400W / 100V line per ch. |
| Amplifier inputs |
6 duty / 1 standby |
| Indications |
Red LED for take over |
| Green - normal / non / c/cover |
| Switching mode |
Dry contact activation by AS4000 / other contacts |
| Changeover alert |
Buzzer, LED |
| Changeover section |
Amplifier outputs only |
| Cable connection |
Plug in connectors |
| Cable size |
2.5 mm sq |
| Dimension (WxHxD) |
482 x 44 x 180 mm |
| Weight |
2.0 kg |
 Front View Of AX700 Rear View Of AX700
|
